How To Wire A Lamp With Multiple Bulbs

They say challenges are what cause us to think better. But how patient could you be if they ask you to wire a lamp with two or more bulb. This is not a drill, but a reality that you might face soon. So, before that happens, you will learn in this article how to wire a lamp with multiple bulbs.

Steps in Wiring a Lamp with Multiple Bulbs

So how to wire a lamp with multiple bulbs? You need to be patient enough to do this. Don’t think about short cuts because if you skip the process, you might end up causing more damage to your lamp. Before you replace the wires in your lamp, you need to take off and unscrew a few of its parts. Without further ado, here are the steps on how to wire a lamp with two bulbs.

Break Up Your Lamp

First, you need to make sure that your lamp isn’t plugged. Then you need to dismember the cover or shade and wire cap housing because this is how to wire a lamp with two bulbs. Next, snap off the outer shell of each bulb socket to unveil the wire connections. Gently take it out by removing the wire nuts and unscrew the connections that keep it in place.

Replace the Old Wires

A new lamp wire will bring out the shine in your lamp, so make sure you got the right size by maintaining a size of 3 lengths. You will notice that your wire is composed of two joined seams. Pull them apart with a length of 2-inches, so later, the two light bulbs will glow evenly. The next step is to remove the insulation on both ends to expose the brass in the wire.

Pull It Up Inside and Connect the Cords

You are two steps closer to the process of how to wire a lamp with two bulbs, so just be patient. Now that the new cord is ready, string it until you reach the socket channels. To grab the end successfully, use a long-nose pliers. When you’re done, you are ready to connect the sockets to the lamp cord.

Time for the Finishing Touches

The last process on how to wire multiple light bulb sockets is by putting the new plugs. Unscrew the cover of the plug then connect each wire to each blade by screwing them securely. Put back the cover and lock the sides by putting back the screws. Your lamp is set! Now plug it and see if turns on, then put back the cover or shade.

Conclusion

It doesn’t matter if your lamp is old. All you need is a bucket of patience and materials to make it work again. Now that we have given you tips on how to wire a lamp with multiple bulbs, you don’t need to think of throwing your lamp away. With just a little screwing, connecting, and replacement of old materials, your lamp can be as good as new!